5/25/2023 0 Comments Routeros raspberry piThen I've decided using the same configuration to add static ip address to rPi's usb0 interface and dnsmasq for dhcp server with the idea to set dhcp client on the lte interface on RouterOS side, but I hit another wall - now the lte interface is gone, RouterOS still detects it in /system resource usb. The Raspberry Pi runs on Broadcom BCM2711 CPU. I've configured the rPi to use cdc_ecm using g_multi and configfs and there you go - RouterOS detected it as LTE interface, but sadly there is not much you can do with it since it's not actual LTE. I would like to ask is it possible to run RouterOS on a Raspberry PI 4 Is it possible to to run RouterOS on that SBC and how to flash it to SD CARD I just need to download the software for ARM64 or ARM and then how to flash it to SD Card. Reading about RouterOS usb support I've decided to change the configuration a little bit using g_multi and configfs(linux virtual filesystem used to configure g_multi and others alike). ![]() When connected to RB using the same g_ether module it only shows it in the /system resource usb again as RNDIS/Ethernet Gadget. When using g_ether and when connected to PC, the PC detects it as RNDIS/Ethernet Gadget and you can assign address, share internet connection to it and so on. The rPi uses dwc2 overlay to control the otg/host functionality and g_ether for the usb interface communication, there are other possibilities as well like g_serial and g_multi. ![]() The mini computer (rPi) has only one micro usb interface connected directly to it's cpu which gives the possibility to configure it as usb host/otg. Recently I've tried to connect Raspberry Pi Zero to my RB962UiGS (hap ac). Current setup is VDSL modem > PFSense > Switch > Routers and machines Works very well and using ntopng I can monitor the network using graphs efficiently.
0 Comments
Leave a Reply. |